Ole stupid me.....again

[Howard]

Hi Bob-

Well here I go again, showing off my intelligence ;)

When I click on the 'CM Editor' icon I get the following screen:

"The CM Editor is only available if you've included the CMS controls in your map or have specified a Command file on the Program Settings Tab"

As you can tell Bob, I haven't progressed very far in my venture to assign Button 11 on the TQ to change Modes. Can you please 'help'......again?

By the way, I just received my replacement TQ from Paula at FS Central, and it appears to be working just fine.

Thanks a lot,
Howard

[Bob Church]

Hi Howard,

>> Well here I go again, showing off my intelligence

When I click on the 'CM Editor' icon I get the following screen:

"The CM Editor is only available if you've included the CMS controls in your map or have specified a Command file on the Program Settings Tab"

As you can tell Bob, I haven&#39;t progressed very far in my venture to assign Button 11 on the TQ to change Modes. Can you please &#39;help&#39;......again? <<

Sure, easy deal. You just need to add the CMS "Controls" to the map. Click the "Add" button (5th from the left, green "+" sign on a joystick icon) just like you were going to add a joystick or throttle to the map. The selection at the bottom of the list will be "CMS Controls". Add those, you&#39;ll get a tab for them just to the right of the tabs for the other controllers. To add the Mode Control, you won&#39;t need to assign anything on the CMS Controls tab, but you have to have it in the map to enable the editor.

>> By the way, I just received my replacement TQ from Paula at FS Central, and it appears to be working just fine. <<

Great! Have fun with it!

Best regards,

- Bob

The StickWorks
http://www.stickworks.com

[Howard]

Thank you Bob, it&#39;s been a long time since I have tried some of this.

Also, my &#39;senior moments&#39; seam to be increasing in frequency. ;)

Best,
Howard