fog
03-05-2005, 08:29 AM
Hi!
First, I am not sure this is the right forum to post this.. but as it has a connection with my proile using the CMS i post it here.
I use FS2004 a lot, and yesterday we tried a new setup. I had 5 CH units connected (2xUSB yoke, 2xUSB Pro pedals and one throttle quadrant). I did set this up so i used some buttons on the quadrant to switch between the two sets of yokes and pedals.
But, when I downloaded the profile, and set the CH manager to mapped mode I got trouble with the FPS in FS2004,... Normally I have 3 units conected, using CMS scripted profiles, and the FP is always up to my locked level (38).. but with 5 units conected it did never exceed 15 FPS..
So i tried several setups, connecting the CH devices to diffeent USB ports, used a USB hub etcetc.. problem was there regardless of how i connected the devices.. Then i tried to set the devices to Direct mode, and problem was gone..
Is there an issue with using more that 3 controllers in mapped mode ?.
Rgd
Freddy Wilhelmsen
First, I am not sure this is the right forum to post this.. but as it has a connection with my proile using the CMS i post it here.
I use FS2004 a lot, and yesterday we tried a new setup. I had 5 CH units connected (2xUSB yoke, 2xUSB Pro pedals and one throttle quadrant). I did set this up so i used some buttons on the quadrant to switch between the two sets of yokes and pedals.
But, when I downloaded the profile, and set the CH manager to mapped mode I got trouble with the FPS in FS2004,... Normally I have 3 units conected, using CMS scripted profiles, and the FP is always up to my locked level (38).. but with 5 units conected it did never exceed 15 FPS..
So i tried several setups, connecting the CH devices to diffeent USB ports, used a USB hub etcetc.. problem was there regardless of how i connected the devices.. Then i tried to set the devices to Direct mode, and problem was gone..
Is there an issue with using more that 3 controllers in mapped mode ?.
Rgd
Freddy Wilhelmsen