PDA

View Full Version : Questions on CMS script

Graf
11-07-2005, 12:38 AM
S!
I saw this script at UBI and thought what the hay and would give it a shot.
I edited my CMS script and checked it, no errors or conflicts. Question is I am not sure what buttons he is using on his profile?
Here is his script:
http://simjunkie.com/images/cms.jpg

I have also attached my profile if someone could be kind enough to take a peek at it and point me in the right direction.
Thanks mucho!
Graf
11-07-2005, 12:46 AM
More thoughts,
is JS1.B25 Joystick 1 button 25? That would be the joystick I presume? Plus are his pedals JS2.A3?
Bob Church
11-07-2005, 03:13 AM
Hi Graf,

The JS1.B25 reference is to the POV Up position on the throttle 8-way hat. Up is either up or right depending on the "Rotate POV" setting on the Program Settings tab. JS1 can't bet he stick because you have no stick in the map. JS1 is just the first tab, the one to the right of Program Settings. Whatever is there is JS1. If you've got a CH stick you should add it to the map even if you're not gioing to program it. Any CH device that isn't in the map essentially gets disconnected when the map is active. If you're using a non-CH stick then the map looks right. The JS2.A3 is correct, too, since the rudder action is on Z axis (A3) and JS2 is the ProPedals.

Hope this helps!

Best regards,

- Bob

The StickWorks
http://www.stickworks.com
Graf
11-07-2005, 03:23 AM
Thanks for the fast reply!
Yes that picture of the script is someone elses script. I have the stick/throttle/pedals and wanted to try and use that script. My question is if I wanted to use button 2 on the throttle to trigger with the pedals what would it be JS2.B2 for the throttle and JS3 for the pedals? My map and script are the download attachments at the bottem of my post.
Thank you for the reply :)
Bob Church
11-07-2005, 04:26 AM
Hi Graf,

Okay. I took a look at your map and the button is right if what you were trying to do was get it to activate with Button 2 on the throttle. The main problem is you need to change the JS2.A3 references to JS3.A3. The pedals are on the third tab and so the reference has to be to JS3. You might want to clear the assignment off of button 2, right now it's set to CM Device 1, Button 18 and you probably don't really want it to activate anything else.

Best regards,

- Bot

The StickWorks
http://www.stickworks.com
Graf
11-07-2005, 04:40 AM
Oops, thanks Bob :D