Aces High Calibration Problem

[FBuzzard]

After many hours of tweaking the CH USB Yoke in the Aces High calibration setup, I cannot figure out what I'm doing wrong. Every axis of flight seems to work well except for the pitch up axis. When pulling back on the Yoke to climb, the plane rocks up and down while it climbs. To say the least its getting very annoying. What am I doing wrong? :unsure:

[Bob Church]

Check the trim wheel. If it's not centered it will increase the pitch sensitivity. Put the Control Manager into Direct Mode, then look at the yoke in the Test/Calibration screen. Watch the numbers in the Raw Data display. With the yoke centered, the elevator axis should be showing a value of 128 or as close as you can get to that. Once the elevator trim is centered, recalibrate the yoke and see if that helps.

- Bob

The StickWorks
http://www.stickworks.com

[FBuzzard]

Hmmm, I checked the direct mode button but nothing seems to be happening when I select calibrate. The highest value allowed is 100. What I did notice is that my machine wanted to recognize a new CH device (again for the second time). Not sure if I should have said no to the install wizard prompt. BTW no active device keeps showing up too.

[MichaelCHProd]

Have you been saying "No" to all the "Found New Hardware" wizards that pop up? :(