Revvin CH products USB + Aces High issues

[SunKing]

I had to do a reformat. So I installed the correct via 4in1 drivers for my mobo so I my apg card runs at 8x.

I've installed the ch manager then downloaded my map. The pc went through the driver install process and calibration showed everything to work fine.

I load Aces High and in the joystick selection screen it shows at 3 Ch Control Manager devices. Only the 1st one my combat stick shows activity when I move it I can see the values change. The other 2 for my pro thorttle and pedals are stuck at 0. Ive reinstalled and tried everything I could.

Any ideas why the game only sees one devices yet the manager sees em all?

[straffo]

Did you recalibrate each one in AH ?

[Revvin]

The device axis will only show movement after you select that device's axis and then click 'Set Input' then click 'Apply' then the axis should show movement. It's one of AH's little keymapper quirks.

[SunKing]

Something is very weird. I went into Aces HIgh and it doens't show values next to my axis and hat switches on my pedals and pro throttle, yet the game sees them , ohwell they are working at least.

Yes I am able to calibrate them in the manager and the game and they seems to work, just can't see the values on the two devices.

[MichaelCHProd]

ahhh Aces High :rolleyes:

[straffo]

Originally posted by SunKing@Jun 2 2004, 05:29 AM
Something is very weird. I went into Aces HIgh and it doens't show values next to my axis and hat switches on my pedals and pro throttle, yet the game sees them , ohwell they are working at least.

Yes I am able to calibrate them in the manager and the game and they seems to work, just can't see the values on the two devices.
Click on "set all input" I had this behaviour at sometime during my migration from X45 to fighterstick.