Mayday-Mayday

[Szollosi]

Hi to my learned fellow enthusiasts,

Please be so kind to help me.
I bought a new CH yoke and pro pedals both USB and have problems with the programing. (Win 2000, Intel Pentium 4, 2,4 GHz, 512 MB RAM etc tops.)
I made everything according to the CH Control Manager 3.0 but my prop and mixture control doesn't working (at the default Cessna 172). I know of course that this Cessna haven't prop control.
The mixture control doesn't working by the yoke but working by the cursor.
If I use the prop control it moves the rudder surface (what can be seen at the outside view) and only at central position of the prop control is the rudder in neutral. Everything else is working well.
The auto mixture is off, sensitivity is 100 %.
I have no idea what could be the reason of this. Please help me.

Of course there is a lot what I do not know about the programing like what for is the axis setting, how can be programmed different buttons on the yoke etc.
I would like to learn all about them but where can I find discription for these ?

Thanks for help in advance

Best regards

Grapesi

[MichaelCHProd]

Did you assign your axis in MFS 200x?

After you make your map you need to then tell MFS what the axis do as MFS does not recognize the "Control Manager Devices" by default.

[Szollosi]

Dear Michael,

Thanks for your information regarding to my problem.
As I am a very beginner at CH products programming sorry to say that but I do not know what does it mean to assign an axis so how to assign my axis in MFS 2000.
Moreover I do not know how to make a map and how to tell MFS what the axis do.

I beg your pardon for my ignorance and ask you to provide me a description how to make the above procedures.

If I understand the whole process and I could make it once I am sure there will be no such problem in the future.

Thanks for help in advance.

Regards

John