Need help installing control manager on XP

[Sabre86]

Had my mother-board die. So I replaced it and had to reload windows.When I tried to use control manager the download button was grayed out and and could not get any profile to work. So I unistalled it and tried to re-install,I unzipped the files and when I click on setup I get this message!

Can't run 16-bit windows program

cannot find file c:\chinstall\setup.exe(or one of its component).Check to insure the path and file name are correct and that all required libraries are available.

Any clues to what is going on?

[Bob Church]

It seems to me that message about the 16-bit file shows up when you try to unzip the self-extractor rather than letting it extract itself. That might be what's wrong. Also, remember you have to download a file before the Mapped Mode button will light up. Immediately after an install, there's no file there to activate and the Mapped Mode button is greyed out.

- Bob

The StickWorks
http://stickworks.com

[Sabre86]

Yea well I had installed over window so everything was intact and should of been working. I un-zipped it using the exe, I dont have win-zip. Anyway I searched the net and finally came across a solution, so if anyone else has this problem this is what worked for me.
Simply exe the file to your root dir. (ie C:/ instead of CHInstall)and run it from there. Worked like a charm. I now have it all up and running good as new!